Jun 17, 2009

Rabbit Bunny Pattern - Origami

By DIY Maven

1.Fold and unfold as shown below.

2.Fold sides to center. (I turned my paper 90 degrees to the right in the second picture.)


3.Fold tip on the right to the left.

4.Fold the previous fold right a little past the edge. (This will be bunny’s tale.)


5.Turn paper over.

6.Fold left point to the right, lining its point up to the straight edge–not the point of the bunny’s tale.

7.Fold in half to back, as shown.

8.Lift the tip up and fold at the bottom. (These will become the bunny’s ears.)

9.Using your scissors, cut down to about 3/4 inch or so from tip (nose) to create two ears.

10.Slide your index finger in one of the ears to separate. Fold down to make the ear ‘flop.’ Repeat on the other ear.

11.And you’re done!

No comments: